Buying guide

What Size Outboard Motor Do I Need?

Reviewed by the Aero Engines Inc team · checked against 25 sources listed below

Short answer: Start with the maximum horsepower on your boat's capacity plate and stay at or below it; Coast Guard rules require that plate on monohull boats under 20 feet. Then match the shaft length to your transom height, usually 15, 20 or 25 inches, so the anti-ventilation plate sits no more than about 1 inch below the bottom of the hull. Finally, choose tiller or remote steering and check the motor's weight against the boat's weight capacity.

How much horsepower can my boat take?

Look for the capacity plate near the helm or transom. Under Coast Guard rules in 33 CFR 183, monohull boats under 20 feet (except sailboats, canoes, kayaks and inflatables) must be marked with a maximum horsepower, along with maximum persons and maximum weight. The plate must be displayed where the operator can clearly see it when getting underway. Tohatsu's advice is simple: never exceed the boat's horsepower rating.

On outboard boats the plate can list two horsepower figures, one for a motor with remote steering and one for a motor without it. That is because the rule that sets the rating gives a higher limit to larger boats that have remote steering and a transom at least 20 inches high.

How is the maximum horsepower calculated?

Builders compute a factor by multiplying the boat's length in feet by its maximum transom width in feet, then look up the rating in Table 183.53. A boat 13 feet or less with remote wheel steering can instead be rated by a performance test.

Factor (length x transom width)Maximum horsepower
0 to 353
36 to 395
40 to 427.5
43 to 4510
46 to 5215
Over 52.5, remote steering and at least 20 in transom(2 x factor) minus 90
Over 52.5, no remote steering or under 20 in transom, flat bottom hard chine(0.5 x factor) minus 15
Over 52.5, no remote steering or under 20 in transom, other hulls(0.8 x factor) minus 25

Flat bottom hard chine boats with a factor of 52 or less drop one step in the table, for example from 5 to 3 hp. Above a factor of 52.5, a result that is not a multiple of 5 may be raised to the next multiple of 5. Worked example: a 16-foot boat with a 6-foot transom has a factor of 96. With remote steering and a 20-inch transom the formula gives 102, raised to 105 hp. The same hull without remote steering gives 51.8, raised to 55 hp. Always go by the plate on your boat, not your own math.

Pontoon boats, catamarans and boats 20 feet and over are outside this marking rule. For those, use the maximum horsepower set by the boat's manufacturer.

How much horsepower do I actually need?

Treat the plate as a ceiling, not a target. Tohatsu lists the factors to weigh after the rating: the weight of the boat, the weight of passengers and gear, and how you use it. Trolling a small lake takes far less power than pulling a skier. Yamaha notes the other side: a motor closer to the boat's maximum can run at lower rpm for the same speed, which can extend its life and improve fuel economy over a smaller motor run near wide-open throttle.

For heavy, slow boats such as pontoons and sailboats, look at thrust models. Yamaha rates its High Thrust motors at up to 60 percent more forward thrust and up to 70 percent more in reverse than standard outboards of the same horsepower. Browse by size: 2.5 hp, 9.9 hp, 25 hp, 60 hp, 90 hp, 115 hp, 150 hp, 200 hp and 250 hp.

How do I measure transom height for shaft length?

Tohatsu's method: measure from the top of the transom, where the motor clamps, straight down to the bottom of the keel. Keep the tape vertical rather than following the slope of the transom. Measure at the exact spot the motor will mount. Mercury stresses this for kicker motors, which sit off center where the transom may be a different height.

Then choose the shaft that puts the motor's anti-ventilation plate no more than 1 inch below the bottom of the boat. That is Mercury's rule, and it is the real test, because nominal shaft sizes are not exact.

Measured transom heightShaft to look forExamples
About 15 in (Tohatsu: 15 to 17 in)Short, 15 inSmall portables, such as Yamaha 2.5 to 9.9 hp
About 20 in (Tohatsu: 20 to 22 in)Long, 20 inYamaha portables, In-Line Four 150 and 200
About 25 inExtra long, 25 inYamaha T9.9 high thrust, In-Line Four 150 and 200, V6 Offshore
About 30 in30 inYamaha V6 Offshore and XTO Offshore

Tohatsu notes that some of its shafts run 2 inches longer than the standard size, so a short shaft can measure 17 inches and a long shaft 22 inches. Compare the measured spec of the motor, not just the size in its name. Tohatsu says most boats need a short or long shaft, with some needing 25 inches.

Should I get tiller or remote steering?

A tiller outboard is steered, shifted and throttled from a handle on the motor. Mercury points out that dropping the console opens up the boat so several anglers can fish comfortably. Tillers are not only for small motors: Yamaha builds power-assisted tiller versions of its In-Line Four 150 and 200.

Remote steering puts the wheel and throttle at a helm. It is the usual choice on boats with a console, and as the horsepower table earlier on this page shows, the Coast Guard formula can allow more horsepower on a larger hull with remote steering. Larger motors may use drive-by-wire controls instead of cables. Suzuki Precision Control, for example, replaces mechanical control cables with electronic wiring, so confirm what controls a motor needs before you buy.

Two-stroke or four-stroke: which should I choose?

Two-strokeFour-stroke
LubricationOil burned with the fuel: premix (Tohatsu: 50:1 after break-in) or oil injectionOil in a crankcase, filled before first start
Oil typeTwo-cycle outboard oil rated NMMA TC-W3Four-cycle marine oil such as NMMA FC-W
New availabilityCheck the model year; Evinrude E-TEC production ended in 2020Honda, for one, sells only four-strokes, from 2 to 350 hp
RunningNeeds oil mixed into the fuel, by hand or by an injection systemYamaha cites better fuel economy and quieter running than older two-strokes
WeightCheck the spec for the exact modelBoatUS warns some can be heavier than an older boat was designed for

EPA tightened emission standards for outboard engines starting with the 2010 model year. If you are looking at a two-stroke, check its model year.

How much does an outboard motor weigh?

Weight matters twice: you have to lift or mount the motor, and it counts against the boat's weight capacity, which the plate lists as pounds of persons, motor and gear. Yamaha's published dry weights for the shortest shaft give a sense of scale:

Yamaha modelShortest shaftPublished weight
2.5 hp portable15 in37 lb
6 hp portable15 in60 lb
9.9 hp portable15 in87 lb
70 hp midrange20 in253 lb
In-Line Four 150 (mechanical)20 in509 lb
V6 Offshore 35025 in629 lb
XTO Offshore 45025 in963 lb

Yamaha measures these without motor oil, gearcase oil and propeller, except for models 25 hp and under, which include a standard propeller. Add fuel, a battery and rigging when you check the boat's weight capacity.

Is an electric outboard big enough for my boat?

For small boats and short trips, often yes. Torqeedo rates its Cruise 3.0 as comparable to a 6 hp gas outboard and suited to displacement hulls up to 3 tons or sailboats up to 30 feet. Its Cruise 6.0 is rated comparable to a 9.9 hp and suited to boats up to 6 tons. Range depends on battery capacity and throttle setting, and the Cruise comes with short or long shafts, so measure your transom the same way. See Torqeedo listings.

Once you know the horsepower, shaft and steering you need, compare prices in How Much Does an Outboard Motor Cost? or browse all outboard motors. For a question about a specific listing, use the contact page.

Common questions

Can I put a bigger outboard on my boat than the capacity plate allows?

The plate's horsepower figure is the maximum set for that hull under Coast Guard rules, and engine makers such as Tohatsu say never to exceed it. Choose a motor at or below the rating.

My boat has no capacity plate. How do I find its maximum horsepower?

The federal marking rule covers monohull boats under 20 feet, so pontoons, catamarans, larger boats, sailboats, canoes, kayaks and inflatables may have no horsepower plate. Ask the boat's manufacturer for its rating, or have a dealer confirm it.

Is a long shaft outboard 20 inches?

Nominally, yes. A short shaft is about 15 inches and a long shaft about 20 inches, but Tohatsu notes some of its shafts run 2 inches longer, so check the motor's measured shaft against your transom.

Where do I measure transom height for a kicker motor?

Measure at the spot where the kicker will clamp, not the center of the transom, from the top of the transom straight down to the bottom of the hull. Pick the shaft that puts the anti-ventilation plate no more than 1 inch below the bottom of the boat.

Do I need a high-thrust outboard?

Consider one if your boat is heavy and slow, such as a pontoon, houseboat or sailboat, or if the motor will be used as a kicker. Yamaha rates its High Thrust models at up to 60 percent more forward thrust and 70 percent more reverse thrust than standard motors of the same horsepower.

How much does a 9.9 hp outboard weigh?

It varies by brand and version. Yamaha's 9.9 hp four-stroke portable is listed at 87 pounds with a 15-inch shaft, measured without oil but with a standard propeller.

Shop the listings

Freight, returns and the startup warranty are set out in our shipping policy, return policy and warranty terms.

Sources

The facts in this guide were checked against these pages. Makers revise specifications, so confirm critical figures with the manufacturer for your exact model.