Buying guides

Buying Guides

Straight answers to the questions buyers ask us most, checked against manufacturer and regulator sources. Prices quoted in a guide come from our live listings.

  • How Much Does an Outboard Motor Cost?

    An outboard motor's price depends mostly on its horsepower, then on whether it is new or used, four-stroke or two-stroke, tiller or remote control, its shaft length, and its age and hours. A remote-control motor may also need controls, steering, gauges and a propeller matched to the boat, which add to the total. The price table on this page shows the lowest, median and highest prices of our current outboard listings at each horsepower, new and used.

  • What Size Outboard Motor Do I Need?

    Start with the maximum horsepower on your boat's capacity plate and stay at or below it; Coast Guard rules require that plate on monohull boats under 20 feet. Then match the shaft length to your transom height, usually 15, 20 or 25 inches, so the anti-ventilation plate sits no more than about 1 inch below the bottom of the hull. Finally, choose tiller or remote steering and check the motor's weight against the boat's weight capacity.

  • Crate Engine Buying Guide: Long Block, Short Block or Turnkey?

    A short block is the block with crankshaft, rods and pistons. A long block adds the cylinder heads, camshaft and valvetrain. A dressed or turnkey engine adds most running parts, but makers such as BluePrint Engines still say not to assume it is ready to run without setup. Whatever you buy, check the included-parts list, follow the maker's break-in, and keep the paperwork its warranty requires.

  • LS Swap Guide: Which LS Engine and What You Need

    An LS swap needs more than the engine: a matching computer and harness, an EFI fuel system that holds about 60 psi, an oil pan and mounts that clear your chassis, and the right flexplate or flywheel and transmission. GM says early LS engines used a 24X crank reluctor and Gen IV engines use 58X, and the controller must match. Iron-block truck engines such as the 5.3L LM7 cost less, while aluminum LS1, LS3 and L92 engines weigh less.

  • JDM Engines Explained: What You Get and What to Check

    A JDM engine is a used engine taken from a vehicle built for Japan's domestic market and imported. What comes with it varies by listing, from a bare long block to a package with harness, computer and transmission. Mileage is usually unverifiable, so judge it by compression, oil condition and timing components. In the US, EPA policy and state rules such as California's Referee inspection limit where a swap is legal on the road.

  • 4L60E vs 4L80E: Differences, Strength and Which to Choose

    The 4L80E is the stronger, heavy-duty GM four-speed automatic: GM rated it for 440 lb-ft of engine torque versus 350 lb-ft for the model year 2000 4L60E. The trade-off is size, with a dry weight of 236 lb against 146.4 lb and roughly 3 more inches of length. The 4L60E has a deeper 3.06 first gear and fits smaller tunnels, so it suits lighter cars and moderate builds, while the 4L80E suits trucks, towing and high-torque engines. Both shift electronically and need a PCM or stand-alone controller.

  • Tremec T56 Magnum vs TKX: Which Manual Transmission?

    TREMEC rates the T56 Magnum six-speed for 700 lb-ft and the TKX five-speed for 600 lb-ft. The TKX is lighter at 99 lb dry versus 140 lb for the Magnum and about 3 to 4 inches shorter, so it fits classic-car tunnels more easily. The Magnum adds a sixth gear with double overdrive and more torque headroom. Choose the Magnum for high-torque LS and late-model swaps, and the TKX for compact restomods comfortably under 600 lb-ft.