Miller Deltaweld 500 Migrunner W/Single Intellx Feeder (230/460V) (951814)

Where the dual-feeder MigRunner carries two spools, this Deltaweld 500 package runs a single standard Intellx feeder instead, built around one wire type at a time. It rolls on a dual-cylinder running-gear rack, a Bernard gun good to 15 feet comes attached, and the single feeder itself measures 16.25″H by 12.38″W by 27.88″L.

Single feeder, same power source

The power source underneath matches the rest of the Deltaweld 500 line: ArcConnect for point-of-use control at the feeder, Accu-Pulse for refined pulse-arc control, and Wind Tunnel Technology with Fan-On-Demand for dust and noise management.

Numbers that matter here

100% duty holds through 500A on this power source, then eases to 60% once draw reaches 575A, across a 30-650A, 10-44V range, weighing 405 lbs with gouging up to 3/8″ carbons. The single Intellx feeder runs wire at 50-780 ipm, handles .023-5/64″ diameter, accepts spools up to 18″ or 60 lbs, and weighs 44.8 lbs.

Because this is the standard feeder rather than the Pro version, it is set up for solid and flux-cored wire, not the Pro's added stainless, metal-cored, or alternate-gas range. This configuration carries no 14-pin receptacle, relying on ArcConnect cabling instead, and Miller includes a manufacturer's warranty for Career Welder-level shops.

Is this the single- or dual-wire version? Single: it runs one Intellx feeder rather than the dual-feeder MigRunner configuration. What wire types does the standard feeder handle? Solid wire and ordinary flux-cored wire; running stainless or metal-cored wire calls for the Pro feeder instead.

Specifications