In Stock & Ready to Freight Crate Engines

LS Classic GMLS9006 LS3 14″ Classic Crate Engine, Unpainted BBC

Brand: LS Classic Series
Condition: Used
$10,494.52
+ $295.00 flat-rate insured LTL freight (details)
$10,789.52 delivered to the continental US
  • Palletized and heavy shrink-wrapped for freight
  • LTL carrier delivery with optional liftgate service
  • Ships in 1–2 business days from Los Angeles, CA
  • Transit typically 3–7 business days, continental US
Ask a question about this unit
Secure checkout by Stripe

Need a matched transmission, controls or wiring package? Speak with a parts specialist.

Details & Inspection Notes

All of our LS Classic components are available, installed, on one of our Classic Crate Engines. We start with a brand new, GM 495 horse power LS3 right out of the box and with a two year warranty. We then paint it orange (if you so desire) and begin assembling your desired components until we have the perfect crate engine for your project. Once completely assembled we put the engine on our in-house run stand, load your Holley EFI ECU with our start-up tune, and run your engine to check for leaks and oil pressure. After we are satisfied that your engine will operate with no issues, we put it back in the original GM crate and ship it directly to you or your builder. Once you receive your engine it is as simple as installing the engine, routing the Holley wiring harness, terminating a couple of power and ground wires, and putting fuel pressure to the engine. We guarantee an easy start up!

All Crate Engines include:

New GM LS3 495 HP Crate Engine with two year warranty
Painted orange or unpainted
Holley Terminator engine management system with O2 sensor and trans control
Corvette water pump, thermostat housing, and balancer
High performance rear dump exhaust manifolds
14″ automatic transmission flexplate
GMLS9006 14″ Classic Crate Engine, unpainted, with cast finish Big Block Chevy Valve Covers

Unpainted
14″ Classic Intake Kit
Cast finish Big Block Chevy style valve covers
Valley plate with oil fill tube and machined finish
Two year warranty

Startup & Installation Checklist

  • Replace timing components, water pump and plugs before initial startup where applicable.
  • Refill all fluids with manufacturer-specified oil and coolant.
  • Verify sensors, ECU pinouts and grounds against your chassis or hull wiring.
  • Startup warranty covers heads, block and internal lubricated components for 30 days from delivery.

Full terms: 30-day startup warranty · returns